SupportDocumentationSwitchesCampus SwitchS7700&S8700&S9700&S12700&S16700Configuration & CommissioningConfiguration Guide

S12700 and S12700E V200R019C10 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.

Configuring 2 to 1 VLAN Mapping

Configuring 2 to 1 VLAN Mapping

Context

When receiving a tagged packet, an interface maps the VLAN ID in the packet to an S-VLAN ID.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port link-type { hybrid | trunk }

    The port link-type is set.

  4. Run port vlan-mapping vlan vlan-id1 inner-vlan vlan-id2 [ to vlan-id3 ] map-vlan vlan-id4 [ remark-8021p 8021p-value ]

    The outer VLAN tag is replaced.