SupportDocumentationSwitchesData Center SwitchCloudEngine 58&68&78&88&98Configuration & CommissioningConfiguration Guide

CloudEngine 8800, 7800, 6800, and 5800 V200R019C10 Configuration Guide - Network Management and Monitoring

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, NETCONF, RESTCONF, OpenFlow, OVSDB, LLDP, NQA, Mirroring, Packet Capture, Packet Trace, Discarded Packet Capture, Path and Connectivity Detection, NetStream, sFlow, iPCA, IOAM, Telemetry, TWAMP, TWAMP Light and Intelligent Traffic Analysis.

Verifying the IPv4 Flexible Flow Configuration

Verifying the IPv4 Flexible Flow Configuration

Context

You can run commands to verify that flexible flow statistics exporting has been configured correctly.

Procedure

  • Run the display forward enp [ slot slot-id ] command to check whether a switch performs NetStream sampling in enhanced mode.

    Only the CE8868EI, CE8861EI, CE8850-64CQ-EI, CE6881, CE6881K, CE6863, CE6863K, CE6881E, CE6820, CE6875EI, CE6865EI, and CE6857EI support this command.

  • Run the display netstream cache ip record record-name [ { inbound | outbound } | destination interface interface-type interface-number | destination ip ip-address | destination port port-number | source interface interface-type interface-number | source ip ip-address | source port port-number | protocol protocol-type | tos tos-number ] * slot slot-id [ chip chip-id ] [ verbose ] command to check detailed NetStream statistics on IPv4 flexible flows on the device.

    Only the CE6880EI, CE6881, CE6881K, CE6820, CE6863, CE6863K, CE6881E and CE5880EI support the chip chip-id parameter.

  • Run the display netstream export ip template command to check the exported template information.
  • Run the display netstream statistics ip slot slot-id [ chip chip-id ] command to check NetStream statistics about IPv4 flows on the device.

    Only the CE6880EI, CE6881, CE6881K, CE6820, CE6863, CE6863K, CE6881E and CE5880EI support the chip chip-id parameter.

  • Run the display netstream { all | global | interface interface-type interface-number } command to check the NetStream configuration.