NetEngine AR600, AR6100, AR6200, and AR6300 V300R021 Web-based Configuration Guide

This document describes how to configure and maintain your routers using the web platform.

Connecting to a WAN Through PPPoE Dial-up

Networking Requirements

Users need to connect to a WAN through PPPoE dial-up. In Figure 1-479, the router used as a PPPoE client obtains an IP address after being authenticated by the PPPoE server, and then it can connect to the Internet. The internal network gateway IP address, namely, the IP address of VLANIF 1, is 10.137.32.1/24.

Figure 1-479 Connecting to a WAN through PPPoE dial-up

Procedure

Click Configuration on the toolbar to access the Configuration page. In the navigation tree on the left, click Configuration Wizard and click Internet Access Wizard to access the Internet Access Wizard page, as shown in Figure2.
Figure 1-480 Internet Access Wizard
Click Configuration on the toolbar to access the Configuration page. In the navigation tree on the left, click WAN Configuration to access the WAN Configuration page, as shown in Figure 1-481.
Figure 1-481 WAN Configuration page
Click WAN Configuration, select Ethernet Interface, and set other parameters, as shown in Figure4.
Figure 1-482 WAN configuration for Broadband dialup
Click OK to complete the configuration.
In the navigation tree on the left, click LAN Configuration to access the LAN Configuration page, as shown in Figure 1-483.
Figure 1-483 LAN Configuration page
Click LAN(Local Area Network) to access the LAN page. Configure the default gateway IP address and subnet mask of the host, as shown in Figure 1-484.
Figure 1-484 LAN page

The configured default gateway IP address is the IP address of VLANIF 1.
Click Apply to complete the configuration.
Check the configuration.
After the configuration is completed, internal users can access the Internet through the router.