Huawei OptiXstar EG8145X6-10 Quick Start for QR code 02
Connecting Cables
- The fiber connector connected to the optical port on the wall varies depending on actual conditions.
- To ensure normal use of fibers, make sure that the fiber bending radius is larger than 30 mm.
- There is a row of ports/buttons at the rear of the device. The ports/buttons are displayed from left to right: On/Off, Power, USB, TEL, LAN4, LAN3, LAN2, LAN1 (Corresponds to No. 1 to No. 5 in the following table).
- There is one button on one side of the device. The button is displayed: Reset (Corresponds to No. 6 in the following table).
- There are two buttons on one side of the device. The buttons are displayed from right to left: WPS, WLAN (Corresponds to No. 7 to No. 8 in the following table).
- There is one port on the bottom of the device near the top right side. The port is displayed: Optical port (Corresponds to No. 9 in the following table).
No. |
Item |
Description |
|---|---|---|
1 |
On/Off |
Powers the ONT on or off. |
2 |
Power |
Connects to a power adapter. |
3 |
USB |
Connects to USB storage devices. |
4 |
TEL |
Connects to the ports on a telephone or fax machine. |
5 |
LAN4 (First Ethernet port from left to right) |
Connects to PCs or IP set-top boxes (STBs). |
LAN3 (Second Ethernet port from left to right) |
||
LAN2 (Third Ethernet port from left to right) |
||
LAN1 (Fourth Ethernet port from left to right) |
||
6 |
Reset |
Press the button for a short time to reset the device, or press the button for a long time (longer than 10s) to restore the device to the default settings and reset the device. NOTE:
Reset Huawei ONTs with caution. Otherwise, the ONTs may fail to access the Internet. If an ONT cannot access the Internet after a reset, contact your Internet service provider. |
7 |
WPS |
When the WLAN is on, press the WPS button (> 3s) and release the button to start Wi-Fi protected setup (WPS) negotiation. |
8 |
WLAN |
Used to enable or disable the WLAN function.
|
9 |
Optical port |
The optical port is equipped with a rubber plug and connected to a fiber for upstream transmission. The type of the optical connector connected to the optical port can be SC/APC. |