PV+ESS+Charger Solution User Manual
S:Smart Dongle Networking
S:Smart Dongle Networking
Starting and Stopping Charging Using an RFID Card
Precautions
- Before charging, make sure your RFID card has been added to the system. For details, see RFID Card Management.
- Before charging, you need to completely insert the charging connector into the charger and vehicle. If the indicator on the charger turns blue on and off cyclically (on for 4s and off for 1s), the charger is successfully connected to the vehicle.
Starting Charging
Place the ring pattern on the RFID card in the swiping area. If the indicator blinks blue fast three times, the card is swiped successfully.
- If scheduled charging is not set, wait until the indicator on the charger turns blue on and off cyclically (on for 0.5s and off for 0.5s), indicating the charging state.
- If scheduled charging is set, the charger enters the waiting state and the indicator turns blue on and off cyclically (pulsating blue for 4s and off for 1s). The charging automatically starts at the scheduled time. You can also swipe the card again to start charging immediately.
Figure 4-12 Charging by card swiping
![]()
Stopping Charging
After the vehicle is fully charged, the charger automatically stops charging. In this case, the indicator is steady blue. You can also swipe the RFID card in the swiping area to stop charging.
Document ID：EDOC1100280349
Views：94729
Downloads：5147
Average rating：5.0Points