S300, S500, S2700, S5700, and S6700 V200R024C00 Configuration Guide - Basic Configuration
This document describes the configurations of Basic, including CLI Overview, EasyDeploy Configuration, USB-based Deployment Configuration, Logging In to a Device for the First Time, CLI Login Configuration, Web System Login Configuration, File Management, Configuring System Startup, BootLoad Menu Operation.
This document describes the configurations of Basic, including CLI Overview, EasyDeploy Configuration, USB-based Deployment Configuration, Logging In to a Device for the First Time, CLI Login Configuration, Web System Login Configuration, File Management, Configuring System Startup, BootLoad Menu Operation.
Deploying Pre-configured Devices Using an Intermediate File
Pre-configured commands are contained in the configuration file delivered together with the device. This configuration file can be customized as required. When the device is running properly, these commands cannot be manually executed.
When the device is running properly, to start the pre-configured device deployment process, specify the configuration file for the next startup again and restart the device. The configuration file for the next startup must contain pre-configured device deployment commands.
Pre-configuration Tasks
Before deploying zero touch devices using an intermediate file, complete the following tasks:
- Configure routing to ensure that the DHCP server, file server, and devices to be configured (have obtained IP addresses) have reachable routes to each other.
- Collect each zero touch device's MAC address or ESN by viewing the barcode label on the device.
Procedure
Perform the following operations in sequence.
Document ID：EDOC1100410529
Views：17541
Downloads：455
Average rating：0.0Points