S300, S500, S2700, S5700, and S6700 V200R022C10 Command Reference
display flow-suppression interface
Function
The display flow-suppression interface command displays the traffic suppression configuration on an interface.
Parameters
Parameter |
Description |
Value |
|---|---|---|
interface interface-type interface-number |
Specifies the type and number of an interface.
|
- |
Usage Guidelines
This command can display the traffic suppression for broadcast, unknown multicast, known multicast, unknown unicast, and known unicast packets on the interface, including rate limiting mode and rate limit value.
Example
# Display the traffic suppression configuration on GE0/0/1.
<HUAWEI> display flow-suppression interface gigabitethernet 0/0/1 storm type rate mode set rate value ------------------------------------------------------------------------------- unknown-unicast percent percent: 90% multicast percent percent: 90% broadcast percent percent: 90% known-unicast percent percent: 100% known-multicast percent percent: 100% -------------------------------------------------------------------------------
Table 14-42 Description of the display flow-suppression interface command output
Item |
Description |
|---|---|
storm type |
Traffic type:
|
rate mode |
Type of the rate limit.
|
set rate value |
Configured rate limit. The rate can be set by the following commands:
|
Document ID：EDOC1100325914
Views：841944
Downloads：918
Average rating：0.0Points