Setting TR-069 Parameters
Set CPE WAN Management Protocol (CWMP) TR-069 parameters to centrally manage endpoints.
Procedure
- Choose System SettingsNetwork and click the TR069 tab.
- Set the TR-069 parameters listed in Table 3-31.
Table 3-31 TR-069 parameters
Parameter
Description
Setting
TR069
Specifies whether to enable the TR-069 function. If this function is enabled, the endpoint will send a session setup request to the Auto-Configuration Server (ACS). Start the ACS before enabling the TR-069 function.
NOTE:If you set this parameter to Enable, you must also set ACS user name, ACS password, ACS server IP address, Report interval(s), CPE user name, CPE password, and Authentication mode.
The default value is Disable.
ACS user name
Specifies the user name authenticated by the ACS after receiving a session setup request from the endpoint. The user name has been specified on the ACS.
No default value is set for this parameter.
ACS password
Specifies the password authenticated by the ACS after receiving a session setup request from the endpoint The password has been specified on the ACS.
No default value is set for this parameter.
ACS server IP address
Specifies the ACS URL, which can be based on an IP address or domain name.- IP address-based URL example: http://10.10.10.1:8086
- Domain name-based URL example: http://company.acs.com:8086 (8086 indicates the ACS port number)
No default value is set for this parameter.
Report interval(s)
Specifies the interval at which the endpoint sends a session setup request to the ACS.
The default value is 1800.
It is recommended that this interval be shorter than the timeout period of the ACS. If this interval is longer than the timeout period, the ACS may be disconnected or the session status may not be updated in time after a session setup timeout.
CPE user name
Specifies the user name authenticated by the endpoint after receiving a session setup request from the ACS. The user name has been specified on the ACS.
No default value is set for this parameter.
CPE password
Specifies the password authenticated by the endpoint after receiving a session setup request from the ACS. The password has been specified on the ACS.
No default value is set for this parameter.
Authentication mode
Specifies the mode in which the endpoint will be authenticated when accessing to the network management system.
The default value is Digest.
If you set this parameter to None or Basic, the system will prompt you that the authentication mode poses security risks. To ensure security, set this parameter to Digest.
STUN
Specifies whether to enable the Simple Traversal of UDP through NAT (STUN) function. If this function is enabled, the endpoint can perform private-to-public network traversal using the STUN server on the TR-069 network.
NOTE:If you set this parameter to Enable, you must also set STUN Server IP Address, STUN Server Port, STUN listen port, STUN User Name, STUN Password, and STUN keep-alive period(s).
The default value is Disable.
STUN server IP address
Specifies the IP address of the STUN server.
No default value is set for this parameter.
Obtain the value of this parameter from the STUN server administrator.
STUN server port
Specifies the port number used by the STUN server to provide the private and public network traversal service.
The default value is 3478.
Obtain the value of this parameter from the STUN server administrator.
STUN listen port
Specifies the port provided by the endpoint for private and public service interaction with the STUN server.
The default value is 3000.
STUN user name
STUN password
Specifies the authentication user name and password of the STUN server.
No default value is set for this parameter.
Obtain the value of this parameter from the STUN server administrator.
STUN keepalive period(s)
Specifies the interval at which the endpoint sends a session setup request to the STUN server.
The default value is 150.
- Click Save to make the settings take effect.