TaiShan Server BIOS Parameter Reference (Kunpeng 920 Processor) 28
Serial Console Configuration
This section describes how to configure serial port redirection on the Serial Console Configuration screen.
Figure 5-57 or Figure 5-58 shows the Serial Console Configuration screen. Table 5-45 describes the parameters.
The Serial Console Configuration screen varies according to the server. For details, see Table 5-45.
Parameter |
Description |
Default Value |
|---|---|---|
Serial Console Redirection |
Sets whether to enable the serial port redirection function. The options are as follows:
|
Enabled |
UART Baud Rate |
Specifies the baud rate of the serial port. The options are as follows:
NOTE:
The options of this parameter vary according to the server. |
115200 |
Data Bits |
Specifies the length of data bits for serial port redirection. The unit is bit. The options are as follows:
NOTE:
This parameter is supported only by the following servers:
|
8 |
Parity |
Sets whether to enable verification for serial port redirection. The option is NO. NOTE:
This parameter is supported only by the following servers:
|
NO |
Stop Bits |
Specifies the stop bit for serial port redirection. The unit is bit. The options are as follows:
NOTE:
This parameter is supported only by the following servers:
|
1 |
Flow Control |
Sets whether to enable control flow for serial port redirection. The option is NO. NOTE:
This parameter is supported only by the following servers:
|
NO |
Terminal Type |
Specifies the emulation type. The emulation type selected in the terminal program must be the same as the emulation type in BIOS. The option is ANSI. NOTE:
This parameter is supported only by the following servers:
|
ANSI |